LED Ceiling Lamp Installation Method

- Dec 24, 2018-

As the heat of home decoration continues to heat up, the changes in ceiling lamps are changing with each passing day. They are no longer confined to the previous single lamps, but are diversified. They not only absorb the luxury and style of chandeliers, but also adopt the ceiling-mounted installation method. It avoids the shortcomings of a small room that cannot accommodate large luxury lighting. The lamp body of the LED ceiling lamp is mounted directly on the roof and is suitable for overall lighting, usually used in the living room and bedroom. LED ceiling lamps should pay attention to the following points during installation and use:

LED ceiling lamp installation method

    1. When installing the ceiling lamp in the masonry structure, it should be pre-embedded bolts, or fixed with expansion bolts, nylon plugs or plastic plugs; wooden wedges should not be used. And the bearing capacity of the above fixing member should match the weight of the ceiling lamp. To ensure that the ceiling lamp is fixed, reliable and can extend its service life.

    2. When fixing with expansion bolts, the bolt specifications should be selected according to the technical requirements of the product. The drilling diameter and the buried depth should be consistent with the bolt specifications.

    3. The number of fixed lamp holder bolts should not be less than the number of fixing holes on the base of the lamp, and the bolt diameter should match the hole diameter; the lamp with no fixed mounting hole on the base (self-punching during installation), each lamp is used for fixing The number of bolts or screws should not be less than 2, and the center of gravity of the lamp should match the center of gravity of the bolt or screw; only when the diameter of the insulation table is 75mm or less, it can be fixed by one bolt or screw.

    4, LED ceiling lamps can not be directly installed on flammable objects, some families for the appearance of paint after the three plywood lining behind the ceiling lamp, in fact, this is very dangerous, must take insulation measures; if the surface of the lamp is hot Insulation or heat dissipation measures should also be taken when combustible materials are used.

    5, LED ceiling lamp should also be checked before installation: 1 lead to the cross section of the wire core of each lamp, copper core soft wire is not less than 0.4mm2, copper core is not less than 0.5mm2, otherwise the lead must be replaced. 2 The connection between the wire and the lamp cap, the connection of the parallel wires between the lamp caps should be firm, and the electrical contact should be good, so as to avoid sparks between the wires and the terminals due to poor contact, and danger occurs.

    6. Educate children not to throw balloons and other objects into the lamps indoors, so as to prevent the decorations hanging on the lamps from falling and injuring people or affecting the decorative effect of the lamps.